Expertise at Chang Gung System

Huang, Ching-An ,Ph.D.
Institution: Chang gung university
Position: Professor
Department: Department of Mechanical Engineering
Address: No.259, Wen-Hwa 1St Road, Gueishan, Taoyuan 33302, Taiwan
Tel: +886- 2118800 ext 5346
E-mail: gfehu@mail.cgu.edu.tw

Focus of Interest:
  • Electrochemical Machining
  • Microstructure Examination
  • Heat Treatment
  • Corrosion Engineering

Education:
  • B.S. National Taiwan University, Taiwan 1986
  • Ph.D., University of Wisconsin-Madison, USA 1992
  • Post-Doctoral Research Fellow, McMaster University, Canada 1993

Selected Main Publications:
  1. C. A. Huang, F.-Y. Hsu, C. H. Yu, “Electropolishing behavior of pure titanium in sulfuric acid-ethanol electrolytes with an addition of water” Corrosion Science 53(2) (2011) pp. 589-596.
  2. C. A. Huang, C. K. Lin, Y.H. Yeh, “The corrosion and wear resistances of magnesium alloy (LZ91) electroplated with copper and followed by 1 μm-thick chromium deposits” Thin Solid Films 519 (15) (2011) pp. 4774-4780.
  3. C.A. Huang, Y.W. Liu, C. Yu, C.–C. Yang, “Role of carbon in the chromium deposit electroplated from a trivalent chromium-based bath” Surface and Coatings Technology 205(11)( 2011) pp. 3461-3466.
  4. C.A. Huang, J.H. Chang, Y.H. Lin, “Sharpening behaviour of W-wire electrodes in 10-25 wt.% NaOH solutions” Corrosion Science 53 (8) (2011) pp. 2566-2574.
  5. C.A, Huang, C.K. Lin, W.-A. Chiou, F.-Y. Hsu, “Microstructure study of the hardening mechanism of Cr-Ni alloy deposits after flame heating for a few seconds” Surface and Coatings Technology 26 (2-3) ( 2011) pp. 325-329.


All Publications List